Is upper floor heating from top to bottom or bottom to top? Are higher floors heating warmer?

Is upper floor heating from top to bottom or bottom to top? For the South, not every house has a heater, but if you have a heater upstairs or downstairs, then you are blessed, because the home will be warmer than the previous winter. So, are higher-rise heating warmer? Let's have a look!

Whether upper floors are heated from top to bottom or bottom to top

Usually top to bottom. Most high-rise heating systems are central heating systems. First, the hot water that has just been burned in the boiler is transported to the highest point of the high-rise residential building through the water pump, and then gravity is used, the principle of hot water is heavy, and the cold water is light. Return water naturally from top to bottom. Walk into each floor, each home, and finally back to the boiler, forming a complete water cycle. High-rise heating systems typically use relatively hot water on the top floor, but the water temperature on the lower levels won't change much due to gravity.

Are higher floors warmer?

In the case of central heating, this is the case. Floor heating is turned on in every household, and the walls are hot, so the house will not be cold. In the case of single-family heating, insulation is provided, and when it is hot, it will not be cold. a long time. Heating from bottom to top and from top to bottom. As long as the design of the heating pipeline is reasonable, the temperature difference between the upper and lower floors will not be very large, but the users close to the main pipe will be heated for tens of minutes first.

Solution for insufficient return pressure

1. First, check whether the filter of the water supply pipe is blocked. If it is blocked, we can replace the filter or clean it. If the pipeline is not cleaned or there are foreign objects in the pipeline, we need to clean the pipeline once, or clean it on time. 2. Due to corrosion, the valves used in the heating system are prone to failure during actual use and cannot be fully opened or closed. If it is determined that there is a problem with the valve, we can replace it. 3. If there is water leakage in the heating system, the return water pressure will be low, and the radiator will not be hot. In this case, we should find the leak and repair it in time. 4. This situation generally does not occur, especially for systems that were running normally before, let alone. However, once it appears, we should optimize the design according to the actual situation. 5. Due to the excessive use of the circulating pump by other users, the water flow in our house is small, so what we have to do is to inform the heating company to help deal with it. 6. When this situation occurs, we can only ask the heating company to deal with it.

(Responsible editor：workmanship)