current location:Home > floor > Can the radiator only open one room? How to use energy-saving heating?

Can the radiator only open one room? How to use energy-saving heating?

2022-10-07 06:50:59 [Materials ] source:iohomedecor.com
Can the radiator only open one room? How to use energy-saving heating?

It is very important to have heating in winter, no matter how cold it is outside, the inside of the house is very warm, and radiators can be installed in each room to maintain the right temperature. So can the radiator in the house be left in only one room and turn off all the others?

Can the radiator open only one room?

This depends on how the radiators in the home are laid, mainly in series and two methods in parallel. If it is connected in parallel, only the radiator in a certain room can be turned on, and the other ones that are not used can be turned off or turned off, which can save energy. But if it is connected in series, you can't just turn on the radiator in one room. As long as one radiator is not turned on, it will affect the normal heating effect. If the central heating is charged according to the heat meter, or if you install a wall-hung boiler for heating, it is more expensive to turn on the full heating of the home than to turn on the partial heating. If central heating is charged according to the area, then the cost of full heating is the same as the cost of opening only one room. In this case, it is better to turn on all the rooms that can be heated.

Is the radiator on 24 hours to save gas?

Generally, if the gas wall-hung boiler is floor heating, it is best to keep it warm for 24 hours. Continuous heating will save both the furnace and the gas. If it is a radiator, if it is only left for four hours, there is no need to turn it off. Intermittent turning on will reduce comfort, and reheating will also take time and gas. If you don't need heat for more than four hours, it's more cost-effective to turn it off. Because if the wall-hung boiler is opened for more than four hours according to the minimum gas consumption, it is more expensive than the maximum gas consumption of half an hour after the shutdown. The radiator usually burns for half an hour, and the room will heat up, which is faster than floor heating. You can also install a thermostat and set the turn-on time an hour before you return, since the radiator circulates water quickly, it will usually warm up in about an hour to reach the temperature you need, and it doesn't need to be on all day. If you can't set the timing, you can use the temperature control valve to adjust the temperature to the lowest, and then turn it on when you come back.

How to use heating to save energy

1. Charge by the heat meter

Use the thermostatic valve to master the know-how, for office workers, it is not recommended after get off work Close all radiator valves. The temperature of the room will drop a lot, and when the valve is turned on after get off work, it will take hours for the room temperature to be comfortable and the heat consumption will be high. So maintain a certain room temperature when no one can set the room temperature to around 12 degrees Celsius during the day. At night, the room temperature should not be too high.

2. Central heating

New heating users can open the valve for heating first, adjust the temperature to the highest, and wait for the indoor temperature to be constant Then, adjust the valve to the appropriate temperature. Although the energy consumption is the largest during this period, the thermal energy consumption will gradually decrease after normal use.

3. Charge by area

Minimize frequent opening and closing of doors and windows during use, and avoid hanging clothes on radiators or installing heat sinks cover to ensure that the radiator can dissipate heat properly. When going out, the temperature control valve can be adjusted to a low temperature, which can effectively maintain the indoor temperature and greatly save energy consumption.

(Responsible editor:Wall decoration)

Recommended articles